| Rules for cleanliness when working on the gearbox |
| t
| Thoroughly clean all joints and surrounding areas before dismantling. |
| t
| Place removed parts on a clean surface and cover them over. Use sheeting and paper. Use lint-free cloths. |
| t
| Carefully cover or seal open components if repairs cannot be carried out immediately. |
| t
| Only install clean components: do not remove replacement parts from packaging until just before installation. |
| t
| Always install new O-rings, oil seals and gaskets. |
| t
| Lightly lubricate O-rings with ATF or Vaseline before inserting to prevent them from getting crushed during assembly. |
| t
| Use only ATF in ATF area. Other lubricants will cause the gearbox hydraulics to malfunction. |
| t
| After installation check the level of ATF in planetary gearbox and top up if necessary → Chapter. |
|
|
|
