A3 Mk2
| Exploded view - selector mechanism (vehicles up to 11.2009) |
Note| Lubricate all bearings and moving surfaces with polycarbamide grease -G 052 142 A2-. |
| 1 - | Cable support bracket |
| q | Secures selector lever cable to gearbox |
| 2 - | Bolt |
| q | Secures cable support bracket to gearbox |
| q | 2x |
| q | 23 Nm |
| 3 - | Selector lever cable |
| q | Do not bend or kink |
| q | If the protective sleeve is damaged, the selector lever cable must be renewed |
| q | → Chapter „Checking and adjusting selector lever cable“ |
| q | → Chapter „Removing and installing selector lever cable (vehicles up to 11.2009)“ |
| q | Do not lubricate cable eye and ball socket |
| 4 - | Nut |
| q | Secures bracket to gearbox |
| q | 2x |
| q | 13 Nm |
| 5 - | Bracket |
| q | For selector lever cable |
| 6 - | Nut |
| q | Secures selector mechanism to body |
| q | 4x |
| q | 8 Nm |
| 7 - | Buffer stop for selector lever |
| q | Clipped onto selector mechanism |
| 8 - | Shift unit |
| q | → Chapter „Operating manual release for selector mechanism from position P (vehicles with fixed selector mechanism cover)“ |
| q | → Chapter „Operating manual release for selector mechanism from position P (vehicles with selector lever boot, up to 11.2009)“ |
| q | → Chapter „Removing and installing shift unit (vehicles up to 11.2009)“ |
| q | Incorporates the following components: selector lever sensors control unit -J587- with selector lever -E313-, tiptronic switch -F189-, selector lever locked in position P switch -F319- and selector lever lock solenoid -N110- (do not touch these components) |
| q | Can be checked via Guided Fault Finding function → vehicle diagnostic tester |
| q | Selector lever sensors control unit -J587- with selector lever -E313-, tiptronic switch -F189-, selector lever locked in position P switch -F319- and selector lever lock solenoid -N110- can only be renewed together with shift unit as a complete unit → Chapter |
| 9 - | Detent spring |
| 10 - | Bolt |
| q | 3.5 Nm |
| 11 - | Pivot pin |
| q | Secures selector lever cable to shift unit |
| 12 - | Bolt |
| q | Secures detent plate to selector mechanism |
| q | 4x |
| q | 3.5 Nm |
| 13 - | Detent plate |
| 14 - | Cover |
| q | For shift unit |
| q | With glued-on gasket |
| 15 - | Nut |
| q | For securing cover to selector mechanism |
| q | 4x |
| q | Self-locking |
| q | Renew |
| q | 9 Nm |
| 16 - | Retaining clip |
| q | Secures selector lever cable to shift unit |
| q | Renew |
