audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing radiator > < Radiator and radiator fans - exploded view

A3 Mk2

Removing and installing radiator outlet coolant temperature senderG83
Removing and installing radiator outlet coolant temperature sender -G83-
   
Removing
l  Engine cold.
–  Open filler cap on coolant expansion tank briefly to dissipate residual pressure in cooling system.
  A02-0061
–  Remove noise insulation → Rep. Gr.50.
  A10-10761
–  Unplug electrical connector -2- at radiator outlet coolant temperature sender -G83-.
  Note
Place a cloth underneath to catch escaping coolant.
–  Pull out retaining clip -1- and detach radiator outlet coolant temperature sender -G83-.
Installing
Installation is carried out in the reverse order; note the following:
  Note
t  Fit new O-ring.
t  Insert new radiator outlet coolant temperature sender -G83- immediately into connection to avoid loss of coolant.
–  Install noise insulation → Rep. Gr.66.
–  Check coolant level → Anchor.
  A19-10623

Removing and installing radiator > < Radiator and radiator fans - exploded view