audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing drive plate > < Flywheel/drive plate and sealing flange - exploded view of components

A3 Mk2

Removing and installing flywheel
Removing and installing flywheel
Special tools and workshop equipment required
   
t  Counterhold tool -3067-
  W00-0026
Removing
l  Gearbox removed.
–  Remove clutch pressure plate → Rep. Gr.30.
–  Mark installation position of flywheel on crankshaft.
–  Attach counterhold tool -3067- in order to loosen bolts.
–  Unbolt flywheel.
Installing
Installation is carried out in the reverse order; note the following:
–  Use new bolts for securing.
–  Fit counterhold tool -3067- the other way round to tighten bolts.
–  Install clutch pressure plate → Rep. Gr.30.
Tightening torque
  A13-0637
ComponentNm
Flywheel to crankshaft 
Bolt length 19.5 mm60 + 90° 1)2)
l  1) Renew bolts.
l  2) 90° = one quarter turn.

   

Removing and installing drive plate > < Flywheel/drive plate and sealing flange - exploded view of components