audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing oil pressure switch F22 > < Oil filter, engine oil cooler - exploded view

A3 Mk2

Removing and installing engine oil cooler
Removing and installing engine oil cooler
Special tools and workshop equipment required
   
t  Drip tray for workshop hoist -VAS 6208-
Removing
  WARNING
Hot steam/hot coolant can escape - risk of scalding.
t  The cooling system is under pressure when the engine is hot.
t  To allow pressure to dissipate, cover filler cap on expansion tank with cloth and open carefully.
–  Drain coolant → Chapter.
–  Remove bracket for ancillaries → Chapter.
  W00-10228
–  Unscrew bolts -4 and 5- and remove engine oil cooler -3- together with seal -2-.
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torques → Chapter „Oil filter, engine oil cooler - exploded view“
  Note
t  Renew gaskets and seals.
t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Electronic parts catalogue.
  A17-10228
–  Install engine oil cooler -3- with new seal -2-.
–  Install bracket for ancillaries → Chapter.
–  Fill up with coolant → Anchor.
  A17-10228

Removing and installing oil pressure switch F22 > < Oil filter, engine oil cooler - exploded view