audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing cylinder head > < Removing and installing camshaft control valve 1N205

A3 Mk2

Removing and installing cylinder head cover
Removing and installing cylinder head cover
Removing
Special tools and workshop equipment required
   
t  Spring type clip pliers -VAS 5024 A-
  W00-1179
t  Puller -T40039-
–  Detach engine cover panel with air cleaner → Rep. gr.24.
  W00-1303
–  Unscrew bolts -arrows-.
–  Remove ignition coils with output stages → Rep. gr.28.
  A13-0558
–  Disconnect ACF pipe from cylinder head cover -1-.
–  Detach valve housing from cylinder head cover -arrows-.
  A15-10198
–  Unscrew crankcase breather line with heat shield from turbocharger -1-.
–  Disconnect ACF line going to turbocharger from cylinder head cover -2-.
–  Loosen cylinder head cover working from outside to inside.
–  Remove cylinder head cover.
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torque → Chapter
  Note
Renew cylinder head cover gaskets if damaged.
–  Tighten cylinder head cover working from inside outwards.
–  Make sure toothed belt cover (top) is correctly fitted.
–  Install ignition coils with output stages → Rep. gr.28.
  A15-10199

Removing and installing cylinder head > < Removing and installing camshaft control valve 1N205