A3 Mk2
| Sealing flanges and flywheel/drive plate - exploded view |
| 1 - | 15 Nm |
| 2 - | Seal |
| q | Renewing → Chapter |
| q | Do not lubricate with oil |
| 3 - | Sealing flange (pulley end) |
| q | Should be positioned on dowel pins |
| q | Removing and installing → Chapter |
| 4 - | Threaded pin, 10 Nm |
| q | Apply locking fluid when installing; refer to → Electronic parts catalogue |
| 5 - | Cylinder block |
| 6 - | Seal |
| q | Renew |
| 7 - | Screw plug, 100 Nm |
| 8 - | Securing bolt for flywheel/drive plate |
| q | Renew |
| q | Removing and installing flywheel → Chapter |
| q | Removing and installing drive plate → Chapter |
| 9 - | Flywheel/drive plate |
| q | Removing and installing flywheel → Chapter |
| q | Removing and installing drive plate → Chapter |
| q | Can only be installed in one position (holes are off-set) |
| 10 - | Intermediate plate |
| q | Must be positioned on dowel sleeves |
| q | Do not damage/bend when assembling |
| q | Is fitted onto sealing flange → Fig. |
| 11 - | Sealing flange (gearbox end) |
| q | With oil seal |
| q | Removing and installing → Chapter |
| q | Do not lubricate with oil |
|
|
