Audi Workshop Service and Repair Manuals

Removing and installing engine mountings Special tools and workshop equipment required

t  Support bracket -10 - 222 A- with hexagon nut -10 - 222 A /27-

t  Eye-head bolt -3368-

t  Engine support bracket (supplementary set) -T40093-

t  Nut from spindle -T40150/6- t  Flange nut M10 or nut M10 with washer

Removing –  Position support bracket -10 - 222 A- on bolted flanges of wing panels using the following tools: t  Rack -10 - 222 A /1- (2x) t  Spindle -10 - 222 A /11- (2x) t  Adapter -T40093/6- (2x) t  Hexagon nut -10 - 222 A /27- –  Replace wing nut from spindle -10 - 222 A /11- (rear right) with hexagon nut -10 - 222 A /27--arrow -. –  Attach hook of spindle to engine lifting eye (left-side).

WARNING Risk of accident because of loose bolt connections. Screw on flange nut or nut with washer -arrow- at least 6 turns to ensure that eye-head bolt -3368- is properly secured. –  Secure eye-head bolt -3368- with flange nut M10 or nut with washer to engine support as shown in illustration. –  Attach spindle -10 - 222 A /11- (right-side) to eye-head bolt -3368-. –  Take up weight of engine evenly with both spindles (but do not raise engine).

–  Remove bolts -arrows-. –  Detach electrical connector -1- for coolant shortage indicator switch -F66- and move coolant expansion tank to side.

–  Remove bolts -1- and -2- and remove connecting bracket. –  Remove bolts -3 ... 6- and detach engine mounting. Installing Installation is carried out in the reverse order; note the following: l  Tightening torques → Chapter „Assembly mountings - exploded view“ –  Check adjustment of assembly mountings (engine/gearbox mountings) → Chapter.