audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Checking oil pressure and oil pressure switch > < Removing and installing oil filter bracket with engine oil cooler

A3 Mk2

Removing and installing oil pressure switchF1
Removing and installing oil pressure switch -F1-
   
Removing
–  Lift off engine cover panel (outside -1- and inside -2-) by pulling up evenly.
  A10-10366
–  Pull cover off air duct (release clips on sides) -arrows-.
  A10-10367
–  Release clips on left and right -arrow A- and unclip air duct at bottom -2-.
–  Swivel air duct (bottom) slightly to the rear and detach air duct (bottom) from retainers -3-.
–  Detach air pipe -1- from air duct (bottom) -arrow B-.
  Note
  A10-10919
Place a cloth below the oil filter housing to catch escaping oil.
–  Unplug electrical connector at oil pressure switch -F1--arrow-.
–  Unscrew oil pressure switch.
Installing
Installation is carried out in the reverse order; note the following:
  Note
Renew seal.
–  Check oil level → Booklet808.
Tightening torque
  A17-0394
ComponentNm
Oil pressure switch to oil filter bracket20

   

Checking oil pressure and oil pressure switch > < Removing and installing oil filter bracket with engine oil cooler