A3 Mk2
| Turbocharger - exploded view |
| 1 - | 10 Nm |
| 2 - | Bracket |
| 3 - | Heat shield |
| 4 - | Oil supply hose |
| q | To connection for oil supply pipe at turbocharger |
| 5 - | Turbocharger |
| q | Can only be renewed together with exhaust manifold and vacuum unit as one unit |
| q | Removing and installing → Chapter |
| q | Before installing, fill turbocharger with engine oil at connection for oil supply pipe |
| 6 - | Vacuum hose |
| 7 - | Gasket |
| q | Renew |
| q | Note installation position |
| 8 - | To particulate filter |
| 9 - | Securing clamp, 7 Nm |
| q | For turbocharger/particulate filter |
| q | Renew |
| 10 - | Exhaust manifold |
| q | Can only be renewed together with turbocharger and vacuum unit as one unit |
| 11 - | 25 Nm |
| q | Renew |
| 12 - | 25 Nm |
| 13 - | Gasket |
| q | Renew |
| 14 - | Connecting pipe |
| q | For exhaust gas recirculation |
| q | When installing, first tighten mountings finger-tight and then tighten to specified torque |
| 15 - | 25 Nm |
| q | Renew |
| 16 - | 15 Nm |
| 17 - | O-ring |
| q | Renew |
| 18 - | Banjo bolt, 60 Nm |
| 19 - | Support |
| q | For turbocharger |
| q | With oil return pipe |
| 20 - | Exhaust gas temperature sender 1 -G235- |
| q | Coat thread of sender with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
| 21 - | Heat shield |
| 22 - | Connection |
| q | For air cleaner/turbocharger intake hose |
| 23 - | 9 Nm |
| 24 - | 10 Nm |
