Audi Workshop Service and Repair Manuals > A3 Mk2 > Power unit | 4-cylinder TDI unit injector engine (1.9 ltr. 2-valve), mechanics | Engine assy,cylinder block,crankcase | Assembly mountings | Checking adjustment of assembly mountings (engine/gearbox mountings)

Checking adjustment of assembly mountings (engine/gearbox mountings)

–	Lift engine cover panel at sides -arrows 1- and pull off towards front -arrow 2-.

–	Release catches and pull fuel filter with hoses attached upwards out of the bracket -arrow- and place to side.

The following specifications must be obtained:

l	There must be a distance of -a- = 13.5 mm between engine support and longitudinal member (right-side).

l	The side of the engine support casting -2- must be aligned parallel to the support arm -1- (distance -x- = distance -x-).

Note

Distance -a- = 13.5 mm can also be checked with a metal rod of suitable size, or similar.

If the distance measured is too large or small, the assembly mountings must be adjusted → Chapter.

Audi Workshop Service and Repair Manuals