Audi Workshop Service and Repair Manuals

Separating engine and dual clutch gearbox Special tools and workshop equipment required

t  Lifting tackle -2024 A-

t  Eye-head bolt -3368-

t  Workshop hoist -VAS 6100-

t  Puller for ATF-supply -T40123 A- Procedure l  Engine/gearbox assembly removed and attached to engine support -T03000-. –  Remove bevel box → Rep. gr.34. –  Remove starter → Electrical system; Rep. gr.27.

–  Remove nut -arrow- and move electrical wiring harness clear.

–  Move breather hose -1- clear -arrows-.

–  Remove eye on puller for ATF-supply -T40123 A- and screw into lower threaded hole for starter bolt as far as stop. –  Secure eye-head bolt -3368- to bore in gearbox housing with two lock nuts -1-. –  Attach lifting tackle -2024 A- to both eyes and to workshop hoist -VAS 6100- as shown in illustration.   Note To adjust to the centre of gravity of the gearbox, the perforated rails of the support hooks must be positioned as shown.   WARNING Accident risk from loose components of lifting tackle. The support hooks and retaining pins on the lifting tackle must be secured with locking pins -arrows-.

–  Remove bolts -1 ... 8- securing gearbox to engine. –  Detach gearbox from engine.   Note Disregard -item A-.