Audi Workshop Service and Repair Manuals

Removing and installing oil filter bracket with engine oil cooler Removing   Note Fit all cable ties in the original positions when installing. –  Drain oil filter housing → Booklet808. –  Remove front coolant pipes → Chapter.

–  Move electrical connector -1- clear and cut open cable ties (if fitted) -arrows-. –  Remove electrical connectors -2- and -3- from bracket.

–  Unplug electrical connector -1- on oil pressure switch -F22--item 1-.

–  Unplug electrical connector -2-. –  Unscrew bolt -1- and move continued coolant circulation pump -V51- to one side (coolant hoses -3- remain connected).

–  Unplug electrical connector -1-. –  Unscrew bolts -arrows- and move solenoid valve for coolant circuit -N492- to one side (coolant hoses -2- remain connected).

–  Unscrew bolts -arrows- and detach bracket -1-.   Note

Place a cloth beneath the oil filter housing to catch escaping oil. –  Unscrew bolts arrows and remove oil filter bracket with engine oil cooler. Installing Installation is carried out in the reverse order; note the following: l  Tightening torques → Chapter „Oil filter bracket and engine oil cooler - exploded view“   Note Renew seals and/or gaskets. –  Install continued coolant circuit pump -V51- and solenoid valve for coolant circuit -N492- → Chapter. –  Install coolant pipe (left-side) → Chapter. –  Install coolant pipes (front) → Chapter.