A3 Mk2
| Poly V-belt drive, bracket for ancillaries - exploded view |
| 1 - | Bolt |
| q | 35 Nm |
| 2 - | Bolt |
| q | Renew |
| q | 50 Nm + turn 90° further |
| 3 - | Vibration damper |
| q | Removing and installing → Chapter |
| q | Can only be installed in one position |
| 4 - | Poly V-belt for air conditioner compressor |
| q | Check for wear |
| q | Before removing, mark direction of rotation with chalk or felt-tip pen |
| q | Removing and installing → Chapter |
| q | Do not kink |
| q | When installing, make sure it is properly seated on pulleys |
| 5 - | Tensioner |
| q | For poly V-belt for air conditioner compressor |
| q | Removing and installing → Chapter |
| 6 - | Bolt |
| q | 35 Nm |
| 7 - | Tensioner |
| q | For poly V-belt for alternator and coolant pump |
| q | Removing and installing → Chapter |
| 8 - | Poly V-belt for alternator and coolant pump |
| q | Check for wear |
| q | Before removing, mark direction of rotation with chalk or felt-tip pen |
| q | Removing and installing → Chapter |
| q | Do not kink |
| q | When installing, make sure it is properly seated on pulleys |
| 9 - | Idler roller |
| 10 - | Bolt |
| q | Tightening torque → Item |
| 11 - | Coolant pump |
| q | Removing and installing → Chapter |
| 12 - | Bolt |
| q | 8 Nm |
| 13 - | Dowel sleeves |
| q | For bracket for ancillaries |
| 14 - | Bracket for ancillaries |
| q | Removing and installing → Chapter |
| 15 - | Bolt |
| q | Different lengths |
| q | Tightening torque and sequence → Fig. |
| 16 - | Bolt |
| q | Tightening torque → Electrical system; Rep. gr.27 |
| 17 - | Alternator |
| q | Removing and installing → Electrical system; Rep. gr.27 |
| 18 - | Sliding bush |
| 19 - | Idler roller |
| 20 - | Bolt |
| q | 23 Nm |
| 21 - | Dowel sleeves |
| q | For air conditioner compressor |
| 22 - | Air conditioner compressor |
| q | With double-sided poly V-belt pulley |
| q | Removing and installing → Rep. gr.87 |
| 23 - | Bolt |
| q | Tightening torque → Rep. gr.87 |
| Stage | Bolts | Tightening torque |
| 1. | -1 … 6- | Screw in bolts by hand until they make contact |
| 2. | -1 … 6- | 23 Nm |
