audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Checking oil pressure and oil pressure switch F1 > < Removing and installing oil filter housing

A3 Mk2

Removing and installing oil pressure switchF1
Removing and installing oil pressure switch -F1-
Special tools and workshop equipment required
   
t  Assembly tool -T10118-
  W00-1148
Removing
–  Remove poly V-belt → Chapter.
–  Pull out oil dipstick.
–  Unscrew bolt -3- and pull out guide tube for oil dipstick -2- and move clear to one side.
  Note
Disregard -items 1 and 4-.
  A24-10297
–  Remove centre noise insulation -fasteners 1 ... 3-.
  A10-1565
–  Unplug electrical connector -1- for magnetic clutch at AC compressor and move electrical wiring clear.
  WARNING
Risk of injury caused by refrigerant.
The air conditioner refrigerant circuit must not be opened.
–  Remove bolts -arrows-.
–  Tie up air conditioner compressor together with refrigerant hoses at front of noise insulation frame (refrigerant hoses remain connected).
  A10-1894
–  Unplug electrical connector -arrow- at oil pressure switch -F1- using assembly tool -T10118-.
–  Remove oil pressure switch -F1-.
Installing
l  Tightening torque → Chapter.
Installation is carried out in the reverse order; note the following:
–  Install air conditioner compressor → Rep. Gr.87.
–  Install poly V-belt → Chapter.
  A17-0388

Checking oil pressure and oil pressure switch F1 > < Removing and installing oil filter housing