| –
| Pull off spring clip -1- together with intake hose from turbocharger. |
| –
| Detach vacuum hose -2- at air cleaner housing. |
| –
| Remove securing bolt -3- and lift air cleaner housing off mounting pin. |
Note | t
| Always use genuine part for air filter element. |
| t
| Hose connections and hoses for charge air system must be free of oil and grease before assembly. Do not use any lubricants containing silicone when assembling. |
| t
| The air cleaner housing must be clean. |
| t
| Secure all hose connections with the correct type of hose clips (same as original equipment) → Parts catalogue |
| t
| To prevent malfunctions, cover all critical parts of the engine air intake tract with a clean cloth when blowing out the air cleaner housing with compressed air. |
| t
| Please observe requirements for disposal. |
| –
| Check for salt residue, dirt and leaves in air intake hose (engine intake side). |
| –
| Check for dirt in air intake hose from air duct. |
| –
| Clean water drain and air cleaner (bottom section). |
| –
| When installing the air filter element, check that it is properly centred in the retainer in the air cleaner (bottom section). |
| –
| Fit the top section of the air cleaner carefully on the bottom section, without using force. Also ensure that both sealing strips are fitted (see item 7, Air cleaner - exploded view). |
| The remaining installation steps are carried out in the reverse sequence. |
|
|
|
