audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing throttle valve module J338 > < Removing and installing intake manifold with fuel rail

A3 Mk2

Removing and installing fuel rail
Removing and installing fuel rail
If the fuel rail has been renewed, intake manifold flap potentiometer -G336- must be adapted to the engine control unit -J623-, see vehicle diagnostic and service information system -VAS 5052-, “Guided Functions”
  Note
Intake manifold must be removed; removing intake manifold → Chapter.
–  Remove hoses from activated charcoal filter.
–  To do this, unfasten hose clip -1-.
   
–  Unscrew two bolts -arrows- on fuel rail.
–  Detach hose connection -1- from intake manifold and unscrew two bolts -arrows-.
  A24-10115
–  Disconnect fuel pipes -2 and 3-.
–  Carefully pry off linkage from intake manifold flap motor -V157--4-.
  A24-10116
–  Unbolt intake manifold flap motor -V157--5-.
  A24-10116
–  Pry fuel rail over retaining lugs -arrows- on intake manifold.
–  Pull fuel rail off intake manifold.
Installing
–  Install in reverse order.
–  Installing intake manifold → Chapter
  A24-10117

Removing and installing throttle valve module J338 > < Removing and installing intake manifold with fuel rail