t
| The procedure when using a fuel extractor without shaft end is basically the same. |
t
| In this case, make a mark -arrow- on the extraction hose at distance -a- = 1,305 mm from the end of the hose using insulating tape. The extraction hose has been properly inserted when the affixed mark is level with the edge of the filler neck. |
t
| If hose is difficult to insert, apply a thin coat of engine oil. DO NOT use silicone-based lubricant. |
–
| Drain fuel tank as much as possible through fuel filler neck. |
–
| Carefully remove extraction hose. |
–
| Extract remaining fuel from right chamber of fuel tank through opening for fuel delivery unit. |
–
| Push hose into left chamber of fuel tank and extract remaining fuel. |
|
|
|