audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Removing and installing engine cover panel > < Air cleaner
Air cleaner - exploded view
   
Air cleaner - exploded view
1 - Hose connection
2 - Air hose
q   To turbocharger
q   Check for dirt and accumulated leaves, etc.
3 - Bolt
q   2x
q   1.5 Nm
4 - Air mass meter -G70-
q   Removing and installing → Chapter
5 - O-ring
q   Renew
q   Use silicone-free lubricant when installing
6 - Bolts
q   For air cleaner (top section)
q   1.5 Nm
7 - Bolt
q   For air cleaner (bottom section)
q   8 Nm
8 - Sleeve
9 - Washer
10 - Air cleaner (top section)
q   Clean out dirt, leaves and salt deposits
11 - Air filter element
q   Always use genuine part for air filter element
q   Removing and installing → Chapter
q   Observe change intervals → Booklet808
12 - Air cleaner (bottom section)
q   Clean out dirt, leaves and salt deposits
q   On vehicles for cold climates, air cleaner (bottom section) with hot-air-intake hose is installed
q   Country-specific version with snow screen
13 - Connection for water drain hose
q   Clean
14 - Water drain hose
q   Clean
15 - Flutter valve
q   Clean and re-install
16 - Intake air duct
q   To lock carrier
q   Clean out dirt, leaves and salt deposits
17 - Spring-type clip
18 - Connecting hose
q   To turbocharger

   

Removing and installing engine cover panel > < Air cleaner