A3 Quattro L4-2.0L Turbo (CBFA) (2009)
-
Remove the glove compartment and the center console. Refer to => Body Interior 68 Removal and Installation
-
Carefully fold back the carpet near the condensation water drain just enough until the drain is visible.
-
Make sure the condensation water drain - B - is routed correctly and is not block with dirt or constricted.
-
Cover area beneath opening - D - for condensation water drain - C -) with absorbent paper (so that any water present does not flow under carpet).
-
Remove condensation water drain - B -.
-
Check condensation water drain of A/C unit - A - for soiling (e.g. using a piece of wire).
-
Check gap between insulation mat installed in center tunnel and valve for condensation water drain - C - above opening - D - in floor panel, there
must be a sufficient large gap to allow water condensation to flow out of valve for condensation water drain - C -.
Installing
Installation is carried out in the reverse order, when doing this note the following.
-
Install the condensation water drain - B - so that it is not twisted or pinched.
-
When installing the carpet, take special care that it does not compress the condensation water drain - B -.