A3 Quattro L4-2.0L Turbo (CBFA) (2009)
7 - Bolt
‹› 90 Nm plus an additional 45° additional turn
‹› Always replace
8 - Trailing Link
‹› Removing and Installing, refer to => [ Trailing Arm with Mounting Bracket ] See: Steering and Suspension/Suspension/Trailing Arm/Service
and Repair/Removal and Replacement/Trailing Arm with Mounting Bracket
9 - Drive Axle
‹› Transmission side tightening torque, refer to
‹› Do not let the drive axle hang down when assembling; the inner joint could be damaged if it is bent too far.
10 - Cap Bolt
‹› 70 Nm plus an additional 90° additional turn
‹› Always replace
11 - Wheel Bearing Housing
‹› Different versions: aluminum and steel
‹› Removing and installing, refer to => [ Wheel Bearing Housing ] See: Wheel Bearing Housing
12 - Wheel Speed Sensor
13 - Bolt
‹› 8 Nm
14 - Bonded Rubber Bushing
‹› Replacement, refer to => [ Wheel Bearing Housing Bonded Rubber Bushing ] See: Wheel Bearing Housing Bonded Rubber Bushing
15 - Nut
‹› 45 Nm
16 - Bolt
‹› 4 Nm
17 - Brake Disc
18 - Dust Cap
‹› Not installed on AWD vehicles
19 - Bolt
‹› Vehicle must be standing on ground when tightening
‹› Always replace after removal
‹› Different versions. Allocation.
‹› Hex head bolt = 200 Nm plus an additional 180° turn
‹› Loosening and tightening the hex bolt, refer to => [ Drive Axle Hex Combination Bolt, Loosening and Tightening ] See: Transmission and
Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Procedures/Rear Suspension/Drive Axle Hex