A3 Quattro L4-2.0L Turbo (CBFA) (2009)
-
Unclip suction jet pump from locking flange - arrows -.
‹› When removing, be sure not to bend floater arm of Fuel Level Sensor 2 (G169).
Installing
‹› Tightening specifications => [ Fuel Delivery Unit and Fuel Level Sensor Assembly Overview ] See: Powertrain Management/Fuel Delivery and
Air Induction/Fuel Pump/Service and Repair/Fuel Delivery Unit and Fuel Level Sensor Assembly Overview.
Installation is in reverse order of removal, note the following:
‹› Replace seal.
‹› When inserting, be sure not to bend floater arm on fuel level sensor 2 (G169).
-
Carefully insert Fuel Level Sensor 2 (G169) - 2 - into fuel tank opening.
-
Clip suction jet pump - 1 - to the locking flange so that it is audibly engaged.
-
Install new locking flange seal dry.
-
Press locking flange down against spring pressure and bring it into installation position.
‹› Tab - 2 - on locking flange faces toward the arrow marking and must lie between tabs - 1 - and - 3 - on fuel tank.
‹› - Arrow - points in direction of travel.
-
Tighten locking ring.