A3 Quattro L4-2.0L Turbo (CBFA) (2009)
Front Subframe Mount: Testing and Inspection
Subframe Mount, Checking Adjustment
Procedure
-
Check dimensions on right mount for engine and transmission:
‹› Both bolt heads - 2 - must be parallel to edge of engine mount support arm - 3 -.
‹› A distance of - x - = 16 mm must be present between engine mount - 1 - and engine support - 4 -.
‹› Distance - x - = 16 mm can also be checked with corresponding round stock.
-
If the distance measured is too small or too large, the subframe must be adjusted. Refer to => [ Subframe Mount, Adjusting ] See: Adjustments.