A3 Quattro L4-2.0L Turbo (CBFA) (2009)
-
Unclip bracket - 2 - for electrical wiring to Oil Level Thermal Sensor (G266) at the subframe.
-
Remove heat shield for right drive axle - arrows -.
-
Remove right drive axle from transmission flange.
-
Place old oil collecting and extracting device ( V.A.G 1782) beneath transmission.
-
Remove bolt for right flange shaft, by installing two bolts into the flange and counter-holding the flange shaft with a pry bar.
-
Remove flange shaft with spring, thrust washer and tapered ring.