A3 Quattro V6-3.2L (BUB) (2008)
Front Door Latch: Service and Repair
Door Lock
Door Lock
1
-
Cover
2
-
Cover
3
-
Socket head bolt M8
-
20 Nm
4
-
Coupling plate
-
When installing door lock, actuating arm of door handle must be engaged into door lock mount.
5
-
Door shell
6
-
Door lock
-
Door trim removed.
-
Disconnect electrical harness connector at door lock.
-
If the same door lock is installed again, disengage operating rod at door handle.
-
If door lock is being replaced, disengage operating rod at door lock.
-
Unclip operating rod at casing from door lock.
-
Unscrew multi-point bolts - 1 - and remove door lock.
7
-
Transfer module
-
Clipped into door handle.
8
-
Bowden cable for interior door mechanism
-
To install, first insert vertically into release lever, then swivel 90 degree and clip into door lock to secure.
-
After installing door lock, pull Bowden cable through cover in - direction of arrow -.
-
When installing, make sure cover is correctly seated in door shell, otherwise it will leak.
-
Only use undamaged covers.
Door Handle Cover