A3 Quattro V6-3.2L (BUB) (2008)
Wheel Speed Sensor: Service and Repair
Speed Sensor at Rear Axle With All-Wheel Drive
Speed Sensor
Removing
-
Release connector - 1 - at speed sensor and disconnect.
-
Remove screw - 1 -.
-
Pull speed sensor - 2 - out from stub shaft.
Installing
Installation is in reverse order of removal, with special attention to the following:
-
Before inserting speed sensor, clean hole inner surface and coat speed sensor all-round with Polycarbamide grease G 000 650.
Tightening specification