A3 Quattro V6-3.2L (BUB) (2008)
-
Remove bolt from vibration damper, using counter-holder tool T10069 to counter-hold.
-
Remove bolts -1 to 11-.
-
Pry off and remove front sealing flange.
-
Drive out seal from removed flange.
Installing
Installation is in reverse order of removal, note the following:
Note: Place a rag over open part of oil pan.
-
Carefully remove any sealant residue from the cylinder block and oil pan.
CAUTION: Wear safety glasses.
-
Remove sealant residue from sealing flange e.g. with a rotating plastic brush.
-
Clean sealing surfaces, they must be free of oil and grease.