A3 Quattro V6-3.2L (BUB) (2008)
Control Module HVAC: Service and Repair
Fresh Air Blower Control Module and Fresh Air Blower
Fresh Air Blower Control Module and Fresh Air Blower
Removing
-
Remove the glove compartment. Refer to => See: Body and Frame/Interior Moulding / Trim/Utility Storage Compartment/Service and
Repair/Storage Compartments and Covers/Glove Compartment.
-
Remove screw clips - A - (different versions - C - and - D -) and remove insulation mat - B -.
-
Remove bolt - A - (if present).
-
If necessary, remove cable ties which bind wiring harness to fresh air blower housing - C -
-
Disengage locking mechanism - B - and rotate fresh air blower housing - C - in direction of arrow.
‹› Connection between fresh air blower housing - C - and A/C unit may be sealed with sealing compound, in this case a great use of force is required
for rotating.
‹› Fresh Air Blower Control Module (J126) and Fresh Air Blower (V2) are installed in housing - C -. On the version that was installed up to model
year 2007, both components were cast with each other and thus cannot be replaced separately