A3 Quattro V6-3.2L (BUB) (2008)
-
Turn ignition coil - 2 - for gas-discharge lamp counter-clockwise - arrow - and detach.
‹› When rotating the ignition coil, the connector - 1 - will automatically come out of the connector housing.
-
Remove the headlamp range control positioning motor from the ball head mount - arrow -.
-
Disconnect electrical connector - 1 -.
Installing
Install in reverse order of removal, noting the following:
-
To make it easier to install the motor, remove the high beam/parking lamp housing cover from the headlamp housing and counterhold the reflector.
-
Install the headlamp range control positioning motor into the reflector ball head mount.
-
Install ignition coil.
‹› If the motors were removed and installed or replaced, then the headlamps must be adjusted.
-
Close the housing lid.
-
Connect battery. Actions to be taken:
‹› Battery in engine compartment => See: Starting and Charging/Battery/Service and Repair/Removal and Replacement/Battery, Engine
Compartment, Disconnecting and Connecting
‹› Battery in luggage compartment => See: Starting and Charging/Battery/Service and Repair/Removal and Replacement/Battery, Luggage
Compartment, Disconnecting and Connecting