A3 Quattro V6-3.2L (BUB) (2008)
Wheel Bearing: Removal and Replacement
FWD
Wheel Bearing Housing Bonded Rubber Bushing
Special tools, testers and auxiliary items required
‹› Press Support (30-506B)
‹› Mounting Universal Joint (41-501)
‹› Sleeve (3160)
‹› Assembly Tool (3301)
‹› Support Arm Bearing Tool (3346)
‹› Carrier Bearing Tool (3350)
‹› Torque Wrench (VAG 1332)
Removing
-
Measure dimension from center of wheel to lower edge of wheel housing. Refer to => [ Rear Axle in Curb Weight Position ] See: Steering and
Suspension/Suspension/Service and Repair/Rear Axle in Curb Weight Position.
-
Remove wheel.
-
Remove coil spring. Refer to => [ Coil Spring ] See: Steering and Suspension/Suspension/Suspension Spring ( Coil / Leaf )/Service and
Repair/Removal and Replacement/Rear Suspension/Coil Spring.
-
Remove wheel bearing/wheel hub unit. Refer to => [ Wheel Bearing Unit ] See: Wheel Bearing Unit.
-
Remove cover plate.
-
Remove bolt - arrow - for lower transverse link - 1 -.
Pressing Out Bonded Rubber Bushing
-
Install tools as shown in illustration.