A3 Quattro V6-3.2L (BUB) (2008)
/Page-1026004.png)
-
Disengage securing clip - arrow -.
-
Remove Engine Control Module (ECM) - 1 - from bracket.
-
Disengage and disconnect rear multi-pin harness connector of Engine Control Module (ECM).
‹› Adaptation values are erased when connectors are disconnected from the Engine Control Module (ECM), DTC memory content remains intact.
Installing
Installation is in reverse order of removal, noting the following:
-
Re-equip Engine Control Module (ECM) with the protective housing.
-
Clean threaded holes for shear bolts of locking compound residue. Cleaning can be performed with a thread cutter (tap).
-
Use new shear bolts.
After installing a new Engine Control Module (ECM), the following work steps must be performed:
-
Activate Engine Control Module (ECM) in "Guided Fault Finding " under diagnostic object "Engine Control Module (ECM), replacing ".
