A3 Quattro V6-3.2L (BUB) (2008)
-
Disconnect electrical connector - 2 - on the accelerator pedal module by pulling the release - 1 - up as far as the stop - arrow -.
All Vehicles
-
Pry off cover using a screwdriver.
-
Remove bolt.
-
Push release tool T10238 into the intended openings - arrow - up to the stop, as shown, and remove the accelerator pedal module.
Installing
-
Tightening specifications.
Installation is in reverse order of removal, note the following:
-
Connect wiring router - 1 - and electrical connector - 2 - to the accelerator pedal module - 5 -.
-
The connector must engage audibly.
-
Push accelerator pedal module onto the securing studs - 6 -.
-
Insert centering pin - 7 - into hole on vehicle floor.
-
Secure accelerator pedal module with the bolt - 3 - and install the cap - 4 -.