A3 Quattro V6-3.2L (BUB) (2008)
Wiring Harness: Procedures
Terminal Housings, Release and Disassembly Notes
Terminal Housings
Terminal Housings, Release and Disassembly, General Information
CAUTION:
Risk of injury.
-
Some tools are supplied with a tool safety clip, which is slid over the tool points after using the tool, in order to protect other workers
from injuries and tool points from damage.
NOTE:
-
Observe general notes for repairs on the vehicle electrical system Vehicle Electrical System, General Information.
-
Always use the release tools intended for the releasing process. Under no circumstances may terminals be pulled forcefully out of terminal
housings.
-
Damaged contact housings must always be replaced.
-
Small screwdrivers may be used as an aid to release the secondary locks.
-
Chamber/pin assignment is located partially stamped in on secondary lock or rear side of terminal housing.
-
Detailed information on component locations of harness connectors, See Electrical Wiring Diagrams, Troubleshooting and Component Locations.
-
Allocation of the correct release tool to the respective retainers VAS 1978/35 instructions.