A3 Quattro V6-3.2L (BUB) (2008)
-
Remove bolt - 1 -.
-
At Steering Column Electronic Systems Control Module J527 , slide a empty set 2.5 mm drill - item 2 - approximately 45 mm into the hole -
arrow 1 -, releasing the retaining detente - arrow 2 -.
-
Pull Steering Column Electronic Systems Control Module J527 down slightly and remove drill.
-
Release retaining clip - arrow - on connector side of Steering Column Electronic Systems Control Module J527 and remove control module from
steering column switch module.
Installing
Install in reverse order of removal, noting the following:
-
Make sure all retaining hooks and connectors are engaged securely.
-
Install the steering column switch module trim.
-
Install the airbag unit and steering wheel.
-
If Steering Column Electronic Systems Control Module J527 was replaced, it must be coded .
-
Select the function or path:
-
Follow further instructions on display of VAS 5051B .
Tightening Specifications
Steering Column Electronic Systems Control Module
0.4 Nm
J527 to steering column switch module
Airbag Spiral Spring/Return Spring With Slip Ring