A3 Quattro V6-3.2L (BUB) (2008)
-
Coat sealing surfaces on the steering gear housing/boot with the grease provided (G 052 168 A1).
-
Slide boot on to steering gear housing until it stops.
-
Tighten new clamp with locking pliers (VAS 6199 ) as illustrated.
Further installation is in reverse order of removal.
Tightening Specifications, refer to => [ Electromechanical Steering Gear Assembly Overview, Generation I ] See: Electromechanical Steering Gear
Assembly Overview, Generation I.
After the installation the vehicle must be measured.
-
Perform vehicle alignment. Refer to => [ Measurement Procedure ] See: Alignment/Service and Repair/Measurement Procedure.