A3 Quattro V6-3.2L (BUB) (2008)
Rear Knuckle Alignment Link: Procedures
Subframe, Lower & Upper Transverse Links, Tie Rod & Level Control System Sensor with Automatic Headlamp Range Control Assembly
Overview (AWD)
1 - Eccentric bolt
^
After loosening, perform vehicle alignment See: Alignment/Description and Operation
^
Do not turn more than 90 degree left or right (that is, smallest to largest possible adjustment)
2 - Self-locking nut, 95 Nm
^
Always replace
^
Always tighten bolts in curb weight position
3 - Eccentric washer
^
Inner bore with tab
4 - Eccentric bolt
^
After loosening, perform vehicle alignment
^
Do not turn more than 90 degree left or right (that is, smallest to largest possible adjustment)
5 - Self-locking nut, 95 Nm
^
Always replace
^
Always tighten bolts in curb weight position
Note:
^
Adjust torque wrench VAG 1332 to 80 Nm when tightening nut.
^
This torque specification applies only in conjunction with insert tool T10179.