A3 Quattro V6-3.2L (BUB) (2008)
Procedure
‹› Do not turn more than 90° left or right (smallest to largest possible adjustment)
5 - Self-Locking Nut
‹› 95 Nm
‹› Always replace
‹› Always tighten threaded connections in curb weight position. Refer to => [ Rear Axle in Curb Weight Position ] See: Service and Repair/Rear
Axle in Curb Weight Position
‹› Adjust torque wrench VAG 1332 to 80 Nm when tightening nut.
‹› This tightening specification applies only in conjunction with insert tool T10179.
6 - Eccentric Washer
‹› Inner bore with tab
7 - Subframe
‹› Removing and Installing, refer to => [ Subframe with Attachments ] See: Front Subframe/Service and Repair/Removal and Replacement/Rear
Suspension
8 - Bolt
‹› 90 Nm plus an additional 90° turn
‹› Always replace
9 - Lower Transverse Link
‹› Removing and Installing, refer to => [ Lower Transverse Link ] See: Rear Knuckle Alignment Link/Service and Repair/Removal and
Replacement/Lower Transverse Link
10 - Self-Locking Nut
‹› 90 Nm plus an additional 90° turn
‹› Always replace
‹› Always tighten threaded connections in curb weight position. Refer to => [ Rear Axle in Curb Weight Position ] See: Service and Repair/Rear
Axle in Curb Weight Position
11 - Bolt
‹› Always replace
12 - Threaded Rivet
‹› M6
13 - Expanding Rivet
14 - Stone Protection Plate
15 - Bolt
‹› 8 Nm
16 - Self-Locking Nut
‹› Always replace