A3 Quattro V6-3.2L (BUB) (2008)
4 - Tube T10263/6
5 - Hydraulic cylinder VAS 6178
6 - Washer
7 - Nut T10263/5
8 - Spindle T10263/4
-
Pretension special tools.
-
Remove bonded rubber bushing by operating pump.
Affects all vehicles
Front or rear bonded rubber bushings, installing
Installation is in reverse order of removal. Observe the following when doing so:
Front and rear bonded rubber bushings have slightly different installation heights. Ensure correct allocation when installing.
Bonded rubber bushing must be installed in the correct direction, note marking on subframe.
-
Insert special tools with bonded rubber bushing into subframe as illustrated.
CAUTION
Thrust piece T10263/3 must be positioned so that locking tabs on bonded rubber bushing align with opening on thrust piece T10263/3.
1 - Nut T10263/5
2 - Washer
3 - Press piece T10263/3
4 - Subframe
5 - Bonded rubber bushing
6 - Press piece T10263/2
7 - Hydraulic cylinder VAS 6178
8 - Washer
9 - Nut T10263/5
10 - Spindle T10263/4
-
Pretension special tool with bonded rubber bushing.
-
Pull in bonded rubber bushing until stop by operating pump.
Note:
^
When pulling in, ensure bonded rubber bushing only contacts subframe lightly.
Part I - Subframe, Lower and Upper Transverse Links, Tie Rod and Level Control System Sensor with Automatic Headlamp Range Control
Tightening Specifications
Part II - Wheel Bearing Housing, Wheel Bearing Unit and Trailing Arm with Mounting Bracket Tightening Specifications