A3 Quattro V6-3.2L (BUB) (2008)
/Page-1348001.png)
Fluid - A/T: Service and Repair
Transmission Fluid, Checking Level and Filling
Transmission Fluid, Checking Level and Filling - 6 Spd. Direct Shift A/T 02E All Wheel Drive
Special tools, testers and auxiliary items required
^
Vehicle Diagnosis, Testing and Information System VAS 5051B
^
Used oil collection and extraction device V.A.G 1782
^
Adapter for oil filling VAS 6262
^
Protective glasses
^
Acid-resistant protective gloves
Note:
^
Rules for cleanliness when working on transmission.
^
General repair notes.
^
Observe notes for direct-shift transmission 02E, Disposal regulations for oils.
CAUTION
^
When working in vicinity of cooler, always ensure clearance to fan - danger of injury!
^
Fan can only switch on by itself.
^
Wear protective glasses.
^
Wear acid-resistant protective gloves.
CAUTION
^
Engine must not be started if there is only a small amount or no transmission oil at all in transmission after a repair or after excessive
outflow of transmission oil.
^
In this case, perform a preliminary filling of transmission fluid for direct-shift transmission.
^
Only transmission fluid for direct shift transmission available as replacement part must be used in the Direct Shift Transmission 02E.
Other oils can cause malfunctions or transmission failure.
Test Conditions
^
Transmission not in emergency operating mode.
^
Vehicle on a flat surface
^
Selector lever in "P", let engine run at idle.
^
Air conditioning and heater switched off.
^
Vehicle Diagnosis, Testing and Information System VAS 5051B connected, Vehicle Self-Diagnosis and vehicle system "02 - Transmission
electronics" selected.
^
At start of test, transmission fluid temperature must not be higher than 30 degree C; allow transmission to cool down if necessary.
Note:
^
The transmission fluid temperature appears in the display of the vehicle diagnosis, testing and information system VAS 5051B.
^
Transmission fluid level changes with transmission fluid temperature.
