A3 Quattro V6-3.2L (BUB) (2008)
Headlamp Washer Pump: Service and Repair
Headlamp Washer System, From 06.2008
Headlamp Washer Pump
Special tools, testers and auxiliary items required
-
Reservoir
Removing
-
Switch off ignition and remove ignition key.
-
Remove the front section of the front right wheel housing liner.
-
Remove fog lamp.
-
Disconnect the electrical connector - 4 - .
-
Place a reservoir under the washer fluid reservoir.
-
Release the securing clip - 2 - in the - direction of the arrow - and remove the washer fluid line - 1 - from the headlamp washer pump.
-
Remove the headlamp washer pump V11 - item 3 - upward out of the washer fluid reservoir.
Installing
Install in reverse order of removal, observing the following:
-
Check the sealing grommet - 1 - for damage.
-
From above, push the headlamp washer pump V11 - item 2 - into the windshield washer fluid reservoir; while doing this the pump is guided by
both mounting tabs - arrows - .
-
Install fog lamp.
-
Install the front section of the front right wheel housing liner.