A3 Quattro (8PA) L4-2.0L Turbo (CCTA) (2011)
/l4-2.0l_turbo_(ccta)/Page-357002.png)
Production Solution
No change.
Service
No repairs are necessary. Please explain to the customer using the following points:
^ When the hood is closed, the line or mark cannot be seen.
^ The headlight beam is not affected, as the line or mark is not on the light emission surface of the lens.
^ The line or mark comes from the slide separator of the molding tool on the transparent part of the lens. The slide is needed for the rear cuts of the lens.
^ On all other models, these slide separators are visible on the transparent portion of the 2K lens, on the sealing edge. The separators could not be
located on the sealing edge of the A3 from model year 2009 because of the different lens design.
The location of the slide on the A3 creates a small mark on the lens, which is a normal condition.
Warranty
This TSB is informational only and not applicable to any Audi warranty.
Additional Information
All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service
manuals for the latest information.
