A4 Cabriolet L4-1.8L Turbo (AMB) (2005)
/Page-1921002.png)
be switched on.
-
Interrogate DTC memory:
A triggered belt tensioner is identified by the fault message "Belt tensioner igniter - Resistance value too great"
-
In addition, the following must also be replaced, if necessary (visual check): all faulty components
Accident not involving activation of airbag
-
If the airbag warning lamp -K75- does not indicate a malfunction, it is not necessary to replace the airbag components. The seat belts should be
checked separately.
After replacing the airbag units or the control unit, affix stickers (only tear-off strips) to the registration card and return the registration card to the
relevant Sales Department or to the Importer for registration.
Storage and transport of airbag units
-
The airbag unit is a class PT 1 pyrotechnic device. Storage and transport are subject to safety legislation relating to hazardous materials
(explosives).
In Germany: Small quantities of materials and articles may be kept in lockable rooms without special storage permission. Dispatch and transportation is
only permitted in officially approved transport containers.
-
Airbag units must not be stored for longer than 3 months.
Disposal of airbag units
-
In Germany airbag units must be rendered unusable prior to scrapping by means of electrical ignition, in accordance with accident prevention
regulations, as pyrotechnic devices can cause injury if activated improperly (e.g. with a cutting torch during scrapping).
-
The airbag unit must only be electrically ignited when installed in the vehicle. Proceed as follows:
-
Disconnect connector from airbag unit and connect wiring harness, Part No. 8D1 971 259, to airbag unit.
-
Installing airbag unit.
-
Cut off connector at other end of wiring harness, Part No. 8D1 971 259, strip the ends of the two wires and slit cable sheath until ends of wires
are at least 30 cm apart.
WARNING!
-
There must be no one in the vehicle.
-
Minimum distance to vehicle: 10 m.
-
Ignite airbag with doors closed and windows open using wiring harness and external battery (outside vehicle).
-
Ensure adequate vehicle ventilation after triggering.
-
Airbags can be disposed of with commercial refuse after removal.
-
Always wash hands after touching airbags which have been ignited.
-
Observe safety rules for handling airbags.
