A4 Cabriolet L4-2.0L Turbo (BWT) (2007)
Clutch Switch: Service and Repair
01X, 6-Speed Front-Wheel Drive M/T
Clutch pedal switch F36, removing and installing, 01X, 6-Speed Front-wheel Drive M/T
Note:
^
Clutch pedal switch F36 may only be installed once so as to ensure a firm fit.
Removing
-
Remove storage compartment on drivers side.
-
Disconnect electrical connector - 1 - on clutch pedal switch.
^
The clutch pedal - 3 - is in the normal position (i.e. not pressed down). The operating rod - arrow of the clutch pedal switch F36 should then rest
against the clutch pedal.
-
Release clutch pedal switch F36 - 2 - by turning 45° counter-clockwise and remove from guide.
Installing
^
Installation is perform in reverse sequence. Note the following:
-
Pull out operating rod - arrow - all the way before installing clutch pedal switch F36.
^
The clutch pedal should be in the normal position (i.e. not pressed down).
-
Guide clutch pedal switch F36 through mounting hole, press against clutch pedal and attach by turning 45° clockwise.
-
Plug in connector for clutch pedal switch F36.