A4 Cabriolet L4-2.0L Turbo (BWT) (2007)
Input Shaft: Overhaul
Input Shaft With 6 Lining Discs
Input Shaft with 6 Lining Discs
CAUTION!
‹› Note the difference between input shafts with 6 and 7 lining discs. Refer to => [ General Information ] See: Continuously Variable
Transmission/Transaxle/Service and Repair/Procedures/01J Transmission/General Information.
Special tools, testers and auxiliary items required
‹› Pressure plate (VW 401)
‹› Seal remover (T40014)
‹› Assembly tool (T10219/1)
‹› Tube (2010)
‹› Tube (VW 416 B)
‹› Pressure stand (T40099)
‹› 2 piece ruler (T40100)
‹› 4 piece calipers (T40101)
‹› 2 piece feeler gauge (T40117) for input shafts with 6 lining discs
‹› Digital depth gauge (VAS 6087)
‹› Protective gloves
‹› Ice spray
Work Procedure
‹› Transmission removed
‹› Observe general repair information. Refer to => [ General Repair Information ] See: Continuously Variable Transmission/Transaxle/Service and
Repair/Procedures/01J Transmission/General Repair Information.
‹› Rules of cleanliness for working on transmissions. Refer to => [ Clean Working Conditions ] See: Continuously Variable
Transmission/Transaxle/Service Precautions/01J Transmission/Clean Working Conditions.
Disassembling
-
Remove the input shaft. Refer to => [ Input Shaft ] See: Removal and Replacement/01J Transmission/Input Shaft.
-
Remove the input shaft cover from the shaft. Refer to => [ Torsen Differential Cover ] See: Rear Final Drive/Differential Cover/Service and
Repair.
-
Place the input shaft on assembly tool (T10219/1).