A4 Cabriolet L4-2.0L Turbo (BWT) (2007)
/Page-1730001.png)
Clutch Disc: Procedures
Adjuster ring in SAC clutch pressure plate, adjusting, 01X, 6-Speed Front-wheel Drive M/T
Note:
^
"SAC" stands for "Self-Adjusting Clutch".
^
When installing a new clutch plate in conjunction with a used SAC pressure plate, the adjuster ring in the pressure plate has to be reset by turning
it back as far as it will go. If you do not reset the adjuster ring in the pressure plate, the SAC pressure plate will operate with reduced clamping
force, which will cause excessive wear, especially of the clutch plate (clutch will then slip).
^
If the clutch plate is not replaced, it is not necessary to reset the adjuster ring.
^
New SAC pressure plates are pre-set accordingly, and do not have to be reset.
Special tools, testers and auxiliary items required
^
Thrust disc VW412
^
Thrust pad 3062
Procedure
-
Insert 3 bolts for securing pressure plate - A - into mounting holes on pressure plate at 120° 1/3 intervals, as illustrated.
-
Screw 3 nuts - B - M8 onto bolts - A - and tighten nuts.