A4 Cabriolet L4-2.0L Turbo (BWT) (2007)
-
Set drive plate in place, using washer with notches - 1 -.
-
Insert new bolts - 3- and tighten to 30 Nm.
-
Check dimension - a - an three points and calculate mean value.
^
Specified value: 19.5 to 21.1 mm
Note:
^
This is measured through the hole in the drive plate to the machined surface of the cylinder block.
If specification is not obtained:
-
Remove driver plate and remove or add shim - 2 -.
-
Repeat measuring procedure by tightening drive plate to 30 Nm.
If specified value is achieved:
-
Tighten bolt to torque specification.