A4 Cabriolet V6-3.0L (AVK) (2003)
/Page-1650003.png)
Note: The inner pad (with expansion spring) has an arrow. The arrow should point in the direction of rotation of the brake disc when travailing
forward. If installed incorrectly this may cause noise problems.
-
Pull off protective sheet on backing plate of outer brake pad.
-
Install outer brake pad onto brake carrier.
-
Secure brake caliper housing to brake carrier with both guide pins to 25 Nm.
-
Install both protective caps.
-
Insert retaining spring into brake caliper housing.
Notes: After inserting the retaining spring into the two holes, press it under the brake carrier. If incorrectly installed, it is not possible to adjust the
wear of the outer pad, and the pedal travel will be increased as a result.
After replacing the brake pads, depress pedal firmly several times with the vehicle stationary, so that the brake pads are properly seated in their
normal operating position.
-
Check brake fluid level and top up if necessary.