–
| Unplug electrical connector at footwell light and, if applicable, at additional loudspeaker -2-. |
Installation is performed accordingly in the reverse sequence. Observe the following: |
–
| First engage storage compartment (driver side) in guides on bottom edge, then clip onto dash panel at top. |
Vehicles with knee airbag |
WARNING Before handling the airbag units (e.g. unplugging the electrical connector) the mechanic must discharge static electricity by briefly touching the door striker plate, or similar. |
|
–
| Make sure connector for knee airbag engages audibly with coupling. |
–
| Switch on ignition with battery disconnected. |
WARNING Make sure nobody is in the vehicle when the battery is being connected. |
|
Note If the airbag warning lamp -K75- indicates a fault following installation, use the vehicle diagnostic, testing and information system -VAS 5051 A- to interrogate, erase and then re-interrogate the event memory. |
|
|
|