A4 Cabriolet Mk2
|
1 - | Airbag unit (front passenger side) |
t | Removing |
– | Disconnect battery earth strap. |
– | Remove glove box → Chapter. |
– | Unplug connector behind airbag unit → Fig. |
WARNING
|
– | Remove brace -7-. |
– | Remove supports -2- behind airbag unit. |
– | Remove nuts -3- (4x). |
– | Remove airbag unit. |
– | Set down airbag unit with impact cushion facing upwards. |
t | Installing |
– | Install airbag unit. |
– | Make sure connector is engages audibly behind airbag unit → Fig.. |
– | Switch on ignition. |
WARNING
|
– | Connect battery earth strap. |
2 - | Support |
q | Must be renewed if airbag has triggered |
q | Remove front passenger's airbag unit. |
q | Unscrew bolts -4- (4x). |
3 - | Nut (4x) |
q | Must be renewed after airbag has been triggered |
q | Tightening torque: 9 Nm |
4 - | Bolts (4x) |
q | Must be renewed after airbag has been triggered |
q | Tightening torque: 9 Nm |
5 - | Connector |
6 - | Frame for airbag unit |
q | Must be renewed if airbag has triggered |
q | Remove front passenger's airbag unit. |
7 - | Brace |
|
Note
|