audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Removing and installing head restraint microswitch > < Removing and installing backrest release microswitch
Adjusting backrest release microswitch
Adjusting backrest release microswitch
  Note
Vehicles up to 05.02, chassis no. 8H 3K 002 450: Attach cable tie -1- to prevent the head restraint and backrest adjuster from malfunctioning.
   
1 - Cable tie
2 - Connector
3 - Fuse
4 - Backrest release microswitch
t  Adjusting and checking operation
–  Remove backrest cover panel → Chapter.
–  Use screwdriver to prise out fuse -3-.
–  Move microswitch -4- so that backrest is deactivated with release lever 1/3 raised.
–  Check operation of backrest at adjustment switch.
–  Backrest is not actuated when backrest release lever is raised by a third.
–  Backrest is actuated when release lever is in rest position.
–  If necessary, correct position of microswitch -4- and check its operation again.
5 - Retaining tabs (2x)

   

Removing and installing head restraint microswitch > < Removing and installing backrest release microswitch